1040 Matrix PRASAR UCS System Manual
By default, SIP Extension is selected as the landing destination for all the three time zones.
• This page displays only those Extension Port Type that are pre defined in the System Pre-requisites
page. For instance, if the value selected for SIP Extensions under Number of Ports Used is zero in
the System Pre-requisites page, then SIP Extension will not be displayed as one of the Port Type. To
know more, refer to “Configuring System Pre-requisites”.
• The Redundancy Notification Call will be displayed in the call logs, if you have configured the UC
Clients (VARTA ADR100/ VARTA AMP100/ VARTA WIN200) or SPARSH VP330 as the landing
destination. However, the notification call will not be displayed in the call logs, if you have configured,
SPARSH VP310/ SPARSH VP510 as the landing destination.
• Redundancy Notification Call is not supported on SPARSH VP248.
• Redundancy notification call will not be applicable, if you select Voice Mail Auto Attendant or OTBG as
the members in the Routing Group.
• Port Number: Enter the port number (software port or routing group number) on which the landing
destination is configured.
If you have selected SIP Extension as the Port Type, enter the software port number of the SIP Extension.
If you have selected Routing Group as the Port Type, enter the routing group number (01 to 96) in this
field.
Similarly, you can configure the landing destination for the Break Hours and the Non-Working hours as per
your requirement.
• Click Submit.
• The Redundancy Notification call is generated 5 minutes after the redundancy process is completed.
• If you have set DND or Call Forward on a extension that is configured to receive the redundancy
notification call, then in such case, the system will override these features and will place the
redundancy notification call on the extension.
Acknowledging Redundancy Notification Call from SPARSH VP310 Extended IP Phone
• You will receive a Redundancy Notification Call, after the redundancy process is completed.
• Lift the Handset/ press the Speaker Key/ press the Headset Key/ CA Key to answer the Redundancy
Notification Call.
202 Reception
Redundancy Notificatio
To Next Page
Loading...