Matrix PRASAR UCS - Page 1078

Matrix PRASAR UCS System Manual 1069
• Select the SNMP Version as supported by your SNMP Manager. You can select from:
•SNMPv1
•SNMPv2c
•SNMPv3
For enhanced security, you must select SNMPv3.
• Configure the System Name. When there are multiple devices connected in the same network, the
name configured helps to identify the PRASAR UCS within the network. The System Name can be a
maximum of 40 characters. Default: Blank.
• Configure the System Contact. It is the name and number of the person to be contacted, in case of
notification. The System Contact can be of a maximum of 40 characters. Default: Blank.
• Configure the System Location. This is the physical location of PRASAR UCS. This information is
helpful to the administrator. The System Location may consist of a maximum of 40 characters. Default:
Blank.
• Configure Allow access to SNMP Manager from to allow/restrict accessibility to the SNMP Manager.
You can select Any IP Address or Specific IP Addresses. Both IPV4 and IPv6 addresses are
supported.
If you want to restrict the accessibility of the SNMP Manager, select Specific IP Addresses, configure
IP Addresses 1 to 5. Default: Blank.
• If SNMP version is set as SNMPv1 or SNMPv2c, configure Community Name.
Community Name identifies the SNMP community in which the sender and recipient of the message
are located. It enables communication between PRASAR UCS and the Manager. The Community
Name can be a maximum of 40 characters. Default: Blank. To avoid unauthorized access, we
recommend you to assign a strong Community Name.
• If SNMP version is set as SNMPv3, the System’s Engine ID is displayed. This is a unique
identification of the system. It is a hexadecimal field with length of 22 characters. The ID consists of:
• Enterprise Number (800086df03 which is fixed)
• MAC Address of the system (MAC address of Ethernet (LAN/WAN) Port)
Security Settings
• If SNMP version is set as SNMPv3, click Security Settings to expand and configure the following.