Matrix PRASAR UCS System Manual 1099
• You may also change the default format for the SMDR Online report for incoming calls, like column position
and field length for calling number, speech duration, type of call etc., as required. For this you need to
configure the settings of SMDR Incoming Online Record Format.
Configuring SMDR-Online using Jeeves
• Login as System Engineer.
• Under Configuration, click Station Message Detail Recording.
• Click SMDR Online.
• Click SMDR Online to expand.
For SMDR - Outgoing Call Online,
• Select the Destination Port for SMDR-Outgoing Call Online. Default: None.
• If you select Ethernet, in Destination IP Address, enter the IP Address of the remote Syslog Server.
Both IPv4 and IPv6 addresses are supported.
In Port, enter the port of the remote Syslog Server. Valid port range is: 514; 1025 to 65535.
For SMDR - Incoming Call Online,
• Select the Destination Port for SMDR-Incoming Call Online. Default: None.
• If you select Ethernet, in Destination IP Address, enter the IP Address of the remote Syslog Server.
Both IPv4 and IPv6 addresses are supported.
In Port, enter the port of the remote Syslog Server. Valid port range is: 514; 1025 to 65535.
For SMDR - Internal Call Online,
• Select the Destination Port for SMDR-Internal Call Online. Default: None.
To Next Page
Loading...