1134 Matrix PRASAR UCS System Manual
How to configure
To be able to use this feature, you must enable System fault log (online or report), and assign a Destination IP
address for the Fault Logs.
If the System Administrator has an Extended IP Phone, you may assign a DSS key for System Fault Log.
For instructions on configuring DSS Keys on Matrix Extended IP Phone, see “DSS Key Settings” in “Configuring
Matrix SPARSH VP330”, “DSS Key Settings” in “Configuring Matrix SPARSH VP248”, “DSS Key Settings” in
“Configuring Matrix SPARSH VP310” and “DSS Key Settings” in “Configuring Matrix SPARSH VP510”.
Configuring System Fault Log using Jeeves
• Login as System Engineer.
• Under Configuration, click System Log.
• Click System Fault Log.
• To generate System Fault Log - Online
• Select the Enable check box.
•In Destination IP Address, enter the IP Address of the remote Syslog Server. Both IPv4 and IPv6
addresses are supported.
•In Port, enter the port of the remote Syslog Server. Valid port range is: 514; 1025 to 65535.
By default, 514 is assigned.
• To generate System Fault Log - Report, that is, offline, whenever desired
• Select the Enable check box.
•In Destination IP Address, enter the IP Address of the remote Syslog Server. Both IPv4 and IPv6
addresses are supported.
To Next Page
Loading...