Matrix PRASAR UCS - Page 123

114 Matrix PRASAR UCS System Manual
Make sure that the Redundancy LAN IP Address and LAN Port IP Address configured in “LAN Port (IPv4
settings)” in Network Parameters are in the same subnet if you wish to use Redundancy. Similarly, this is
also valid for the WAN IP Address.
Depending on your network scenario, the LAN/ WAN IP Address configured in “Configuring Network
Parameters” is the Virtual IP.
This IP Address is used for communication. The Virtual IP is assigned
to the server which is in the active state.
Make sure that the Virtual IP is configured in all the clients
— IP Phones and VARTA UC Clients
.
Similarly, you can connect the Backup Server.
• Enter the LAN/WAN port IP Address (as configured by you in the Network Parameters of the Primary
Server) in the address bar and login again as System Engineer.
• Under Configuration, click Redundancy Configuration.
Redundancy Configuration
• Enable Redundancy: By default, this check box is disabled. To use Redundancy feature, select the check
box.
• Server Mode: To configure the first system as Primary Server, select Primary. This is the main server that
responds to the client requests.
Default: Primary.