Matrix PRASAR UCS System Manual 225
• Click SIP Extension Settings.
The page of SIP Extension 1 opens.
• You may select the SIP Extension number you want to configure.
The parameters of the SIP Extension number you selected will appear on this page.
For PRASAR UCS upto 2100
41
SIP Extensions can be registered with the system. PRASAR UCS supports
IPv4 Addresses only for registering Extended IP Phones.
• Select the Use SIP Extension check box to enable the SIP extension. Default: disabled.
•In Name, enter a name for the SIP Extension, which may be the name of the person who will use the SIP
Extension or the name of a Department. The name you enter here will be displayed as the Caller ID of the
SIP Extension on the remote user's phone, when the SIP Extension user makes calls.
The name may consist of a maximum of 18 alphanumeric characters.
• Enter the SIP ID for the extension. The SIP ID is necessary for registering the SIP Extension with the
Registrar of the system. It is the number with which you can call the SIP Extension. Any extension user of
the PRASAR UCS can call a SIP Extension by dialing the SIP ID assigned to the SIP extension. SIP ID of
each SIP Extension must be a unique number string of a maximum of 6 digits. Any combination of digits
from 0 to 9 and the characters * and # are allowed. You cannot assign the same SIP ID to more than one
extension.
To assign SIP IDs according to your preference and requirement to a range of SIP Extensions, see
“Assigning Access Codes to a Range of Extensions”.
By default, the SIP IDs are Blank.
41. PRASAR UCS SME Application supports 250 SIP Extensions.
To Next Page
Loading...