252 Matrix PRASAR UCS System Manual
Start S/W Port No.
Enter the software port number from where you want to configure
the first extension.
For example: You want to configure the extensions from software
port number 1, then enter 1 as the software port number.
Use SIP Extension
Select Yes to enable the SIP extensions. If you select No, the SIP
extensions will not get registered with the server.
SIP Hardware Template
Enter the template number of the SIP Hardware Template you want
to assign to the extensions. By default, the SIP Hardware Template
number 01 is assigned.
The SIP Hardware Template contains voice quality related features
such as Voice Codec selection, Tx and Rx Gains, Echo
Cancellation, Jitter Buffer and related parameters.
Check if the values in this template fulfills the requirements of the
extensions. If the Template number 01 fulfills the feature
requirements, retain the Template number 01.
If a different set of SIP hardware features are to be allowed to the
extensions, then prepare another template and enter that template
number in this field.
To know how to customize the template, refer to “SIP Hardware
Template”.
Station Basic Feature Template
Enter the template number of the Station Basic Feature Template
you want to assign to the extensions. By default, Station Basic
Feature Template number 01 is assigned.
The Station Basic Feature Template has a set of features like Time
Table, Class of Service, Toll Control, Operator,
Storage of Incoming and Outgoing Calls, Outgoing Trunk Bundle
groups.
Check if the values in this template fulfills the requirements of the
extensions. If the Template number 01 fulfills the feature
requirements, retain the Template number 01.
If a different set of features are to be allowed to the extensions,
then prepare another template and enter that template number in
this field.
To know how to customize the template, refer to “Station Basic
Feature Template”.
Parameters Description
To Next Page
Loading...