Matrix PRASAR UCS - Page 313

304 Matrix PRASAR UCS System Manual
Enable
Distinctive
Ring
Select the Enable Distinctive Ring check box,
to set different ringing patterns to distinguish
between different types of call events. The
following types of call events are supported:
• Internal Call
•Trunk Call
• Auto Call Back
• Auto Redial
•Alarm
• Emergency
• Operator Alarm
• Message Wait
•Priority
• Emergency Conference
Default: Disabled
Matrix SPARSH VP710
Call Progress
Tone
Select the region to apply the Call Progress
Tone prevailing there. Default: Custom.
Matrix SPARSH VP710
Time Zone
Select the Time Zone of the region/country
where the Standard SIP Phone is installed.
Default: + 05:30 India (Calcutta)
Matrix SPARSH VP710
Daylight
Saving Time
Mode
Select the Daylight Saving Time Mode that
should be applied to the selected Standard SIP
Phone. Default: Automatic.
Matrix SPARSH VP710
DST Type
Select the DST Type that should be applied to
the Standard SIP Phone, either DST by Date
or DST by Week. Default: DST by Date
Matrix SPARSH VP710
If DST Type =
DST by Date
Start Month
Select the Month from when DST should be
applied.
Matrix SPARSH VP710
Start Day
Select the Day from when DST should be
applied.
Matrix SPARSH VP710
Start Hour
Select the Hour from when DST should be
applied.
Matrix SPARSH VP710
End Month Select the Month when DST should end. Matrix SPARSH VP710
End Day Select the Day when DST should end. Matrix SPARSH VP710
End Hour Select the Hour when DST should end. Matrix SPARSH VP710
Offset
(minutes)
Configure the DST Offset timer value in
minutes. Valid Range:-300 to +300. Default:
Blank
Matrix SPARSH VP710