Matrix PRASAR UCS - Page 314

Matrix PRASAR UCS System Manual 305
If DST Type =
DST by Week
Offset
(minutes)
Configure the DST Offset timer value in
minutes. Valid Range:-300 to +300. Default:
Blank
Matrix SPARSH VP710
DST Start
Month
Select the Month from when DST should be
applied.
Matrix SPARSH VP710
DST Start
Day of
Week
Select the Day of Week from when DST should
be applied.
Matrix SPARSH VP710
DST Start
Day of
Week Last
in Month
Select the DST Start Day of Week Last in
Month.
Matrix SPARSH VP710
Start Hour
of Day
Select the DST Start Hour of the Day. Matrix SPARSH VP710
DST Stop
Month
Select the Month when DST should end. Matrix SPARSH VP710
DST Stop
Day of
Week
Select the Day of Week when DST should end. Matrix SPARSH VP710
DST Stop
Day of
Week Last
in Month
Select the DST Stop Day of Week Last in
Month.
Matrix SPARSH VP710
End Hour of
Day
Select the DST End Hour of the Day. Matrix SPARSH VP710
Date Display
Format
Select the Date Display Format for the
Standard SIP Phone. Default: WWW MMM DD
Matrix SPARSH VP710
Time Display
Format
Select the Time Display Format for the
Standard SIP Phone. Default: 24 Hr
Matrix SPARSH VP710
Primary NTP
Server
Select the Primary NTP Server Address with
which you want to synchronize the Date and
Time of the Standard SIP Phone. Default:
None. Make sure you configure the desired
NTP Server Address/es in the “Third Party IP-
Phone General Parameters”.
Matrix SPARSH VP710
a. If the Standard SIP phone is in the same network (LAN) as PRASAR UCS, select Use LAN Port IP Address as
Registrar Server Address.
If the Standard SIP phone is in the Global Network and PRASAR UCS is connected to Internet over WAN,
select Use WAN Port IP Address as Registrar Server Address
If the Standard SIP Phone is connected in the Global Network and PRASAR UCS is located behind a NAT
Router, and STUN is programmed, select Use Router/STUN's IP Address as Registrar Server Address. Make
sure the Router’s Public IP Address is configured in the Network Parameters.
If Dynamic DNS is configured in the Network Parameters, select Use Dynamic DNS Host Name as Registrar
Server Address.