360 Matrix PRASAR UCS System Manual
• SIP Trunk No.: Select the SIP Trunk No., from 1 to 99 that you wish to configure.
• Enable SIP Trunk: By default, this check box is disabled, that is, the SIP trunk is disabled, disallowing
incoming and outgoing calls. You may keep it disabled if the SIP trunk is not functioning.
To be able to make incoming and outgoing calls from the SIP trunk, select the Enable SIP Trunk check
box.
• Name: You may assign a 'Name' to each SIP trunk to facilitate identification. Whenever there is an
incoming call without CLI on this port, the Name you have configured will be displayed on the landing
extension.
The Name assigned to the SIP trunk may consist of a maximum of 18 characters. The Name of the port
may be the name of the ITSP the SIP trunk is subscribed with (recommended).
• SIP ID: Enter the SIP User ID provided by the ITSP. SIP User ID is the ID that callers will use to call this
SIP trunk.
The SIP User ID may be a number or text for remote parties to call on the SIP trunk. For example, if SIP
URI provided by the ITSP is 12345@abc.com, enter 12345 in this field. SIP User ID may consist of a
maximum of 40 characters. All ASCII characters are allowed.
• SIP Trunk Mode: You may select SIP Trunk Mode as Proxy or Peer-to-Peer, according to your
requirement.
If you are using the services of an Internet Telephony Service Provider (ITSP), select Proxy to register this
SIP trunk with the ITSP.
If you are not using this service, select Peer-to-Peer.
Proxy/Registrar Parameters
• Click Proxy/Registrar Parameters to expand.
• Registrar Server Address: Enter the Proxy/Registrar Server Address. Both IPv4 and IPv6 addresses are
supported. The Server Address may be an IP Address or a Domain name, of maximum 40 characters. By
default, it is Blank.
• Registrar Server Port: Enter the Registrar Server Listening Port. The valid range is from 1025 to 65535.
By default, 5060 is set as the Listening Port of the Registrar Server.
To Next Page
Loading...