Matrix PRASAR UCS System Manual 361
• Authentication User ID: Enter the Authentication ID provided by the ITSP for this SIP trunk. The
Authentication User ID may be a string of 40 characters (maximum), including ASCII characters. By
default, it is Blank.
• Authentication Password: Enter the Authentication Password provided by the ITSP for this SIP trunk.
The Authentication Password may be a string of 24 characters (maximum), including ASCII characters. By
default, it is Blank.
• Check SIP ID During Incoming Call: By default, this check box is enabled. During Incoming Call Routing
to select a SIP trunk, PRASAR UCS compares the SIP ID received in the Request URI of the INVITE
message with the SIP ID configured on the SIP Trunk.
If you do not want PRASAR UCS to check the SIP ID received in the Request URI of the INVITE message,
clear the Check SIP ID During Incoming Call check box.
• Send REGISTER Message: With this parameter you can select whether or not the system should send
REGISTER message from the SIP trunk. By default, this check box is enabled allowing REGISTER
message to be sent from the SIP trunk.
• Allow registration for any contact: Enable this check box if you wish to register the SIP trunk with an
ITSP. In this case even if you do not receive proper contact header from the ITSP, the SIP trunk will get
registered.
• Send OPTIONS as Heartbeat: With this parameter you can select whether or not the system should send
the OPTIONS message periodically to the Proxy Server to monitor its availability. Calls can be made and
received only if the Proxy Server is alive.
If the Proxy Server is unavailable, like no response is received, the status of the SIP Trunk will display
“Heartbeat Failed” along with the Reason for Failure.
To view status of the Proxy Server, go to SIP Trunk Status.
If you enable Send OPTIONS as Heartbeat, you must configure the Heartbeat Interval.
• Heartbeat Interval: Define the Heartbeat Interval (Seconds), the time period, from 10 to 999
seconds, after which PRASAR UCS should send the OPTIONS message to the Proxy Server. Default:
30 seconds.
• Re-registration Time (sec): The Registrar Server deletes an entry of its client from its database on expiry
of a fixed timer, which is set by the Registrar Server. PRASAR UCS sends a registration request before
this Timer expires to remain registered on the server.
Enter the value of the Timer after which the system should send registration request to maintain
registration binding with the server. The valid range of this timer is from 00001- 65535. By default the
Timer is set to 3600 seconds.
• Registration Retry Time (sec): This Timer stands for the period between retries for registration. If the
registration attempt fails, PRASAR UCS sends the registration request on the expiry of this Timer again.
The system continues to send the registration request till it gets registered. The valid range of this timer is
from 00001- 65535. By default the Timer is set to 00010 seconds.
To Next Page
Loading...