380 Matrix PRASAR UCS System Manual
• Define the Time Zone, that is, the start and end time, when the LCR should be applied for the outgoing
calls. The Time Zone you define is stored at an Index number from 1 to 8.
• For each Time Zone that you define, select the Trunk as your first preference, that is, Preference 1. Select
the trunk of your second, third and fourth preference. When the trunk you selected as first preference is
busy, the system will route the call through the next trunk you have set that is free.
• Refer to the table you prepared for assigning Cost Factor to trunks.
• For example, you want calls made during 9am to 8pm to be routed through BSNL SIP trunks (SIP-001 and
-002). If these trunks are busy, you want the system to route calls through the Reliance SIP trunks (SIP-
003). When this line is busy, you want the system to attempt to route calls through the Tata SIP Trunk
(SIP-004).
• You want calls made between 8pm to 9am to be routed through BSNL SIP trunk 001 only.
• At Time Zone Index 1, define the Time Zone start and end time in 24 Hours:Minutes format, enter the Cost
Factor you assigned to SIP-001 (01) and SIP-002 (02) as Preference 1 and Preference 2 respectively.
Enter the cost factor you assigned to SIP-003 (07) and SIP-004 (08) as Preference 3 and Preference 4
respectively.
• Similarly, at Time Zone Index 2, define the Time Zone in 24 Hours: Minutes format. Enter the Cost factor
you assigned to SIP-001, that is, 01 as Preference 1, 2, 3, and 4. When calls are made during this time
period, they will be routed through SIP-001 only.
• If you have finished defining Time Zones and the preferred trunks for the time zones, configure the Time-
based LCR using Jeeves.
Time Zone
Index
Time Zone Cost Factor
Start Time
(HH:MM)
End Time
(HH:MM)
Preference
1
Preference
2
Preference
3
Preference
4
1 09:00 20:00 01 02 07 08
2 20:01 08:59 01 01 01 01
3
4
5
6
7
8
To Next Page
Loading...