Matrix PRASAR UCS System Manual 35
After installing the modules into the system, place the cover and affix the screws.
Connect a computer to the LAN/WAN Port of system with the Ethernet cable supplied for the port.
Open a Web browser on the computer to access the Embedded Web Server, Jeeves.
Activate the Key provided in the License Voucher for the Application. For instructions, see “License Management”.
External USB Ports (Device Port) 3.0
PRASAR UCS supports two external USB ports — USB1, USB2 on the fascia of SPARK200. Both USB ports can
be used as COM Ports by connecting the USB to COM Converters.
The USB to COM Converter will not be provided by Matrix.
The following USB to COM Converters are supported:
• Prolific PL2303 by BAFO
• CH341 by Winchiphead
If you use any other USB to COM Converter, it may not function properly.
The USB to COM Port has a DB-9 connector.
The ports allows you to connect a PC to the system, so that you can install and operate the following features:
• set up and run software applications such as PMS and CAS on any PC on the LAN.
• generate Station Message Detail Record (SMDR) Reports on any PC on the LAN.
• capture “System Activity Log” and “System Fault Log”, Hotel Motel Activity Log.
To Next Page
Loading...