34 Matrix PRASAR UCS System Manual
• Secure the module with the screws on the studs.
• Follow the same steps to install another module.
Removing the VOCODER Module
• Locate the VOCODER Module you want to remove from the board.
• Remove the screws from the module and keep them aside.
• Firmly hold the module and ease it out of the PCI connector carefully.
• Replace the screws on the studs.
VMS Interface and the Internal USB Ports
The System supports a maximum of 64 VMS channels. By default, both PRASAR UCS SME/ PRASAR UCS ENT
offers 4 pre-activated VMS channels. To activate additional VMS channels, you must purchase — PRASAR VMS
CHNL4 or PRASAR VMS CHNL16. To know more, refer “License Management”
SPARK200 supports two internal USB Ports:
• One Internal USB Port has a pendrive inserted into it (factory fitted). The pendrive which is provided to you
by default contains the VMS data, Extended IP Phones firmware and the system firmware.
• The other Internal USB Port is for future use.
You can replace the default pendrive with a new one having more space. To do so, you need to format your
new pendrive with FAT32 file format and then copy all the contents of the factory fitted pendrive into the
new pendrive.
Switch-off the system and then replace the pendrive. The system will not detect the new pendrive if you do
not restart the system after replacement.
Make sure while replacing the pendrive, you insert it in the same USB Port where the factory fitted
pendrive was inserted.
To Next Page
Loading...