Matrix PRASAR UCS System Manual 45
4. If you want to use a Headset (not supplied) with your phone, you may plug a headset with a 2.5 mm single
connector into the headset jack headset jack with the symbol on the left side panel of the phone, as
illustrated in the figure below.
OR
You may plug a headset with an RJ9 connector into the headset port at the bottom of the phone, marked
with the symbol , as illustrated in the figure below.
5. Connect the LAN Port of SPARSH VP248 to the LAN Switch/Hub or a Router, according to your installation
scenario.
6. To connect your phone to a computer on your desk, use an Ethernet cable (not supplied with this phone) to
connect the PC Port of the phone to the LAN Port of the computer.
7. Plug the connector of the Power Adapter in to the power jack at the back of the phone
7
. Use only the
adapter provided with the phone to prevent any damages that may arise from the use of other adapters.
7. The SPARSH VP248 does not have a power switch.
Headset
Handset
Foot Stand
Keyhole
Slot 1
Keyhole
Slot 2
To Next Page
Loading...