Matrix PRASAR UCS - Page 578

Matrix PRASAR UCS System Manual 569
The number of attempts to re-enter can be configured by setting the parameter Retry counts for
Authority Code password in the “System Timers and Counts”.
• User A can now make outgoing calls.
• If the Walk Out mode set for A is One Call, A will automatically be logged out from the extension after one
call.
• If the Walk Out mode set for A is Multiple Calls, A can make as many calls as desired, and remains
'walked-in' until the A dials the feature code to 'Walk-Out', or until another extension user walks into the
same extension.
• If a call budget has been assigned to A’s Authority Code, A will be able to make calls till the assigned
amount is consumed.
• Details of the calls made by A are recorded by the Authority Code in the Station Message Detail Recording
Report (SMDR) for Outgoing Calls.
• The SMDR report can be printed using the Authority Code as filter.
This way, the organization can know the details of calls made by each user as well as have control over the
expenses.
How to configure
For Authority Codes to work, you must:
• Configure the Authority Code Table.
• Assign a Station Basic Feature Template to the Authority Code, with the desired Class of Service, Toll
Control and features/facilities.
• Enable the parameter Store Outgoing Calls in the Template assigned to the Authority Code, if you want
details of outgoing calls made using Authority Codes.
• Assign a Station Advanced Feature Template to the Authority Code with the desired Walk-Out Mode
• Assign each user a Call Budget, if required.
• Change the Retry Counts for the Authority Code, if required.
Configuring Authority Code Table
• Make a list of users you want to assign Authority Codes to and their respective passwords.
• Login as System Engineer.