590 Matrix PRASAR UCS System Manual
Thus, the entries you will need to make in the ANT table will be as follows:
• The entry for 10-digit numbers to be dialed out after adding the prefix ‘1’ will be as shown in the first row of
this table. The 10-digit number is represented with the X character in the Dialed Numbers column. Since
no digit is to be stripped off, ‘0’ is entered in the Strip Digit column. As the prefix ‘1’ is to be added, this
number is entered in the Add Prefix column. The system will add 1 as prefix before dialing out numbers
from 0000000000 to 9999999999.
• Similarly, the entry for 7-digit numbers starting with 2 to be dialed out after adding the prefix ‘1315’ will be
as shown in the second row of this table. The system will add 1315 as prefix before dialing out numbers
from 2000000 to 2999999.
• The entry for all numbers beginning with 91 to be stripped off the first 2 digits and ‘0’ to be added as prefix
will be as shown in the third row of this table. When users dial numbers beginning with 91, the system will
strip off the first two digits and add 0. For example, when a user dials the number 919925801882, the
system will dial out 09925801882.
Automatic Number Translation also forms the basis of “Multi-Stage Dialing”.
How to configure
To apply Automatic Number Translation on a trunk,
• Decide which of the SIP trunks that are to be assigned the Automatic Number Translation (ANT) feature.
• Decide the number of ANT tables you need. You can program 8 different tables, with a maximum of 32
entries in each.
• Make the tables on a piece of paper by drawing three-column tables. In the first column of a the table, write
the dialed numbers that need to be modified before being dialed out from the trunk. For each dialed
number in the first column, enter the number of digits you want the system to strip off (if required) from this
number in the second column. In the third column enter the number you want the system to add as prefix
(if required) before dialing out the number.
• Configure the Automatic Number Translation Table in the system using the tables you prepared.
• Enable the Automatic Number Translation check box in the Outgoing Trunk Bundle (OGTB) of the trunk.
• Assign the Automatic Number Translation Table you configured to the OGTB of the trunk.
Configuring Automatic Number Translation using Jeeves
• Login as System Engineer.
• Click Configuration.
Dialed Numbers Strip Digit Add Prefix
XXXXXXXXXX 0 1
2XXXXXX 0 1315
91 2 0
To Next Page
Loading...