Matrix PRASAR UCS System Manual 591
Configuring the ANT Table
• Click Automatic Number Translation.
• Choose any table number from 1 to 8.
• In the Dialed Number column of the table you chose, configure the numbers you expect the extension
users to dial. The Dialed Numbers can be a maximum of 16 characters. Default: Blank.
When you want to specify number-length without specifying the numeric digits, use the character X to
represent the digit. X represents any number from 0 to 9.
• In the Strip Digit column, enter the number of digits you want the system to strip off from the Dialed
Number before the dialing out this number. The valid range is from 00 to 16. Default: 0.
• In the Add Prefix column, enter the number you want the system to add as prefix to the Dialed Number
before the system dials out this number. The Prefix can be a maximum of 40 characters. Default: Blank.
• Click Submit.
Enabling Automatic Number Translation on Trunks
• Under Configuration, click Outgoing Trunk Bundle to open the page.
• In the OG Trunk Bundle of the desired trunk, select the Automatic Number Translation (ANT) Apply
check box to enable.
To Next Page
Loading...