618 Matrix PRASAR UCS System Manual
(However, if SIP Trunk-1 would have been assigned Pulse Rate Option ‘2’, the Pulse Rate type ‘06’
would have been selected as shown in Area Code Table)
• Finally, for Pulse Rate Type ‘03’ PRASAR UCS will check the Normal Pulse Rate Table. PRASAR
UCS will consider the Cost for the First Unit as 001.00 (As ` or $ as per applicable currency) for the
duration of 30 seconds and for the additional unit also, the cost will be considered as 001.00 for the
duration of 30 seconds. This data will be used for calculating the total cost of call based on the total
duration of the call.
Similarly, when there are Special Tariffs offered on certain days, the system will check the Discounted Pulse Rate
Schedule and the Discounted Pulse Rate Table.
The days on which the special rates are to be applied must be configured in the Discounted Pulse Rate Schedule.
The duration and cost of the First unit and the Additional units must be configured in the Discounted Pulse Rate
Table according to the Time Zones.
How to configure
To be able to use Call Cost Calculation, you must do the following:
• Define the Unit and Service Charge on the basis of which call cost is to be calculated.
• Assign Call Cost Calculation Pulse Rate Option and the Call Cost Calculation Schedule on the trunks on
which you want to apply this feature.
• Configure the Pulse Rate Types for the Pulse Rate Option you assign to the trunk.
• You may configure different Pulse Rate Types:
• For Normal Days configure the pulse rate in the Normal Pulse Rate Table.
• For Special days configure the pulse rate in the Discounted Rate Table. If you configure the Discounted
Pulse Rate Table, you must also configure the Discounted Pulse Rate schedule.
• Configure the Area Code Table.
Configuring Call Cost Calculation using Jeeves
To configure call cost calculation parameters,
• Login as System Engineer.
• Under Configuration, click the Call Cost Calculation.
Service Charge
By default, no Service Charge is applied on call cost by the system. Service Charge on call cost is generally applied
in Hotels and other organization which charge users for the calls made by them.
If you want to apply Service Charge,
To Next Page
Loading...