Matrix PRASAR UCS System Manual 55
4. Connect the Handset to the Phone body.
• Plug the long straightened end of the phone cord into the handset jack on the left side panel of the
phone marked with the handset symbol .
• Plug the other (short straight) end of the phone cord into the jack at the bottom of the handset.
5. If you want to use a Headset (not supplied) with your phone, you may plug a headset with a 3.5 mm single
connector into the headset jack headset jack with the symbol on the left side panel of the phone, as
illustrated in the figure above.
OR
You may also plug in a headset with RJ9 connector into the headset port on the left side panel of the
phone, marked with the symbol .
6. Connect the LAN Port of SPARSH VP310 to the LAN Switch/Hub or a Router, according to your installation
scenario using the Ethernet cable.
7. To connect your phone to a computer on your desk, use an Ethernet cable (not supplied with this phone) to
connect the PC Port of the phone to the LAN Port of the computer.
To Next Page
Loading...