Matrix PRASAR UCS - Page 700

Matrix PRASAR UCS System Manual 691
How it works
At the time of installation, when you select the Region (according to the geographical location of the site where the
PRASAR UCS is installed), PRASAR UCS sets the country-specific CPTG type defined for the selected Region. To
see default CPTG types applicable for each region, see “CPTG Region Codes”.
For countries that use different frequencies and cadences for the same tone, e.g. USA, only one
frequency/cadence among the group is considered. See “Default CPTG Type” at the end of this topic.
How to configure
Programming of Call Progress Tones involves configuration of three parameters: CPTG Type (Region), CPT
related Timers, and Dial Tone Type.
The country-specific CPTG type is set automatically by the system when the 'Region' is selected. However, if
required, the System Engineer can change the CTPG type set by the system.
Configuring CPTG Parameters using Jeeves
• Login as System Engineer.
• Under Configuration, click Regional Settings.
• Click Call Progress Tones.
• To set the Call Progress Tone Type, select the desired Region from the list.
• Select the desired Dial Tone Type from Type 1 or Type 2.
• Click Submit.
To change CPT-related Timers
• Under Configuration, click System Timers and Counts.