Matrix PRASAR UCS - Page 74

Matrix PRASAR UCS System Manual 65
Connect the Wi-Fi USB Adapter into the USB port of the phone.
You can purchase the Wi-Fi USB Adapter from Matrix as an optional peripheral device to support wireless
network.
7. To connect your phone to a computer on your desk, use an Ethernet cable (not supplied with this phone) to
connect the PC Port at the bottom of the phone to the LAN Port of the computer.
8. Plug the connector of the Power Adapter in to the power jack at the back of the phone
10
. Use only the
adapter provided with the phone to prevent any damages that may arise from the use of other adapters.
If you want to use Power over Ethernet (PoE), ensure that your LAN supports PoE. Supply power through
an 802.3af connection on the LAN Port of the phone. In this case you need not connect the Power Adapter.
9. Plug the Power Adapter into a power outlet.
If both the power options, that is, PoE as well as Power Adapter are available to the phone, then the phone
will derive power from the PoE enabled LAN Switch.
10. Switch ON power supply.
When you power the phone, the boot process will be initiated in the following sequence.
• All keys with LED, including the Speaker key, and the Ringer LED, will glow.
• The LCD display will light up and booting message appears.
• While loading the application then the loading message appears on the phone display,
• The phone makes DHCP Discovery and fetches its IP Address and Server Address from the DHCP
Server.
If you want to change the Network Settings/Server Settings or want to use Wi-Fi for connectivity, press
Settings .
Refer to the SPARSH VP330 User Guide, for detailed instructions:
• To change the Network Settings of the phone and configure the network parameters.
• To use Wi-Fi for connectivity and configure its parameters.
• On getting the IP Address and Server Address, the phone initiates Auto Configuration to download the
configuration files from PRASAR UCS.
• On successful download of all configuration files, the phone attempts to register with PRASAR UCS.
• On successful registration, the Home screen appears.
The phone will register successfully, only if the SIP Extension parameters in PRASAR UCS have been
correctly configured as per your installation scenario.
Refer to the SPARSH VP330 User Guide to know more.
10.The SPARSH VP330 does not have a power switch.