Matrix PRASAR UCS - Page 75

66 Matrix PRASAR UCS System Manual
Connecting SPARSH VP510 as Extended SIP Extension
You are recommended to complete the following steps before connecting the Matrix Extended IP Phone to the
system when used with PRASAR UCS application:
• Decide the location of the Extended IP Phone, whether within the same network or outside, according to
your installation scenario.
If you want to use the DHCP Server for assigning IP Address to the Extended IP Phone, select DHCP
option 224 and Data Type as ‘String’ and program the LAN or WAN Port IP Address /Domain Name and
SPARSH Port in the format “IP_Address:Port” in your DHCP Server as per your installation scenario.
• Login to Jeeves. For instructions, read the topic
“Configuring Basic PRASAR UCS Settings”.
• Assign an extension number (SIP ID) to the Extended IP Phone. For instructions on assigning SIP ID, see
“Configuring SIP Extensions”.
For the SIP extension number you assigned to the Extended IP Phone, you must configure the necessary
parameters in PRASAR UCS so that Extended IP Phone can register as a SIP Extension. For instructions,
see the topic “Configuring SIP Extension Settings as per the Extended Phone Type” under Configuring SIP
Extensions.
Now, follow the steps described below to install the Extended IP Phone:
1. Unpack the SPARSH VP510 box and verify package contents.
2. You can mount the phone on a wall or on the desk.
3. When you mount SPARSH VP510 on a wall,
• Use the mounting template to drill holed of appropriate size and distance.
• Fix the screw grips in the holes you drilled.
• Fix two screws in the holes on the wall, ensuring that they are aligned with the Keyhole Slots 1 and 2 of
SPARSH VP510. The screws should protrude from the wall to fit into the Keyhole Slots.
• Now, mount the phone with the screws into the Keyhole Slots.
Keyhole
Slot 1
Keyhole
Slot 2