Matrix PRASAR UCS - Page 786

Matrix PRASAR UCS System Manual 777
• Click Submit.
Setting Day/Night Mode using DSS key
You cannot switch to Break Hours or As per Timetable assignment using the DSS key. This can be
achieved only by logging in through Jeeves.
How to configure
• Login as System Engineer.
• Assign a DSS Key for Day/Night Mode to the required extension. To know more about assigning a DSS
Key for a specific feature, refer to “DSS Keys Programming”.
• To enable the toggle functionality of the DSS Key, select the Toggle Day/Night mode through ‘Set Day/
Night Mode Key’ check box. To know more, refer to “Setting Day/Night Mode from SE mode using
Jeeves”.
How to use
• Press DSS Key assigned to Day/Night Mode.
When you press the DSS Key of extension, the system overrides the Time Table assigned to that
extension. According to the current Day/Night Mode, it switches to Working Hours/Non-Working Hours.
The following table displays the LED indication of DSS key with Toggle functionality disabled.
The following table displays the LED indication of DSS key with Toggle functionality enabled.
Model Event Color Cadence
SPARSH VP248/
SPARSH VP310/
SPARSH VP510
Day Mode Set Blue Continuous ON
Night Mode Set Red Continuous ON
Break Hours Mode Violet Continuous ON
System set to work as per Time Table -- OFF
Model Present Mode
Next mode on pressing
Day/Night Mode DSS Key
LED Color
after toggle
Cadence
SPARSH VP248/
SPARSH VP310/
SPARSH VP510
As per Time Table
(Day Mode)
Night Mode Red Continuous ON
As per Time Table
(Night Mode)
Day Mode Blue Continuous ON
As per Time Table
(Break Hour Mode)
Day Mode Blue Continuous ON
Day Mode Night Mode Red Continuous ON
Night Mode Day Mode Blue Continuous ON
Break Hour Mode Day Mode Blue Continuous ON