Matrix PRASAR UCS System Manual 807
• Trunk Feature Template: A Trunk feature template is assigned to each Incoming Reference ID. You
can enable different features in the Trunk Feature Templates. A different Trunk Feature Template can
be assigned to each channel or a range of channels, such as set Auto Answer Time Zone wise, allow
DID according to the time zone. Hence incoming calls can be answered and routed in different ways.
For more details refer the topic “Trunk Feature Template”.
• Click Submit.
• After the Incoming Reference Table has been configured you must configure the DDI Routing Table.
DDI numbers can be assigned to extensions users, Department Groups, Routing Groups depending on
the organizations requirement.
You can configure as many as 224 DDI Reference ID’s with different DDI numbers and landing
destinations. To configure the DDI Routing Table,
• Under Configuration, click DDI Routing.
• Click DDI Routing Table and configure the following parameters:
• DDI Routing Reference ID: You must configure the parameters to apply DDI Routing against the same
ID as assigned in the Incoming Reference Table. This ID is a link between the Incoming Reference
Table and the DDI Routing Table.
DDI Routing Ref. ID’s in the DDI Routing Table act as identifiers. This Reference ID is assigned in the
Incoming Reference Table.
When there is an incoming call the system checks the Incoming Reference ID assigned to the trunk.
The system tracks this ID from the Incoming Reference Table.
• Start DDI Number: This is the first DDI Number from where the DDI range starts. You must only enter
the DDI number. For example, if the Pilot Number is 2630555. If 10 DDI numbers have been taken,
then the DDI Number range is from 555 to 564. The Start DDI Number in this case is 555.
• Total DDI Numbers: The total number of DDI numbers for you want to set the same landing
destination. For example, if the Start DDI Number is 555, Total DDI Number is 1, then the landing
destination selected will only be for the DDI Number 555. If Start DDI number is 556 and the Total DDI
Numbers is configured as 10, then the landing destination will be for the entire range of numbers, that
is from 556 to 565.
• DDI Number of Digit: The number of digits in a DDI number. Suppose 100 DDI numbers are supported
on a SIP Trunk, then the Number of Digits for that Trunk should be configured as 3. Suppose 10 DDI
numbers are supported on another SIP Trunk, then the Number of Digits for that Trunk should be
configured as 2.
• Route to Destination: The incoming calls on the DDI numbers can be placed on extensions users,
Department Groups, Routing Groups depending on the organizations requirement.
Configure the following for the parameters for the landing destination:
• Port Type: Select the port type to place the DDI call from the following:
• Department Group
• Quick Dial
To Next Page
Loading...