814 Matrix PRASAR UCS System Manual
• Under Configuration, click DISA - CLI Authentication.
• You can configure as many as 999 numbers in this table, by clicking the tabs of the index on the top of the
table.
• Refer to the list of remote user numbers and the corresponding PRASAR UCS extension numbers you
made.
• In the Calling Party’s Number, enter the number of the remote users whom you want to allow access to
DISA using CLI Authentication. The system will match the CLI of the callers with the numbers you store
here.
• For each Calling Party Number, in the Auto Login as field, select the extension Port Type (SIP Extension,
or Virtual Extension) and Port Number you want to allow access to after the Calling Party Number is
authenticated.
• Click Submit.
How to use
If you are a Remote user, to be able to use DISA, you must know:
• the number of the Trunk on which DISA is enabled and the variant of DISA enabled on this trunk.
• the number of the extension and the user password which you want to access, if using DISA with PIN
Authentication.
• the duration of DISA Idle State Timer so that you may dial digits accordingly, without delay.
• the special digits to be dialed during a DISA login session.
To Next Page
Loading...