Matrix PRASAR UCS System Manual 815
Dialing Special Digits
After successful login, you will be required to go on-hook, go off-hook, use 'flash', use 'pause' or dial characters like
A, B, C, D, from your remote device to use the features and facilities of PRASAR UCS.
PRASAR UCS will not be able to understand the conventional way of dialing 'flash' key, therefore, the server
supports specific codes for specific activities. If these codes are received during a DISA session, PRASAR UCS
interprets it and performs the associated activity.
When you are in DISA mode, use the following codes to indicate an activity:
To use DISA,
• Dial the number of the Trunk on which DISA is enabled for the current time zone, Working, Break, Non-
working hours.
• PRASAR UCS answers the call. You will get music.
If DISA PIN Authentication-Multiple Calls is enabled,
• You will get beeps at the end of music.
• Dial DISA Login Code 1079 during the beeps.
• Dial the extension number. You will get beeps.
• Dial the User Password for the extension during the beeps.
• You get feature tone on successful login.
• Dial the special digits #0 to go On-hook and then #1 to go Off-hook, you get the dial tone. Dial the number
to make your calls like any local extension. For example, making an external call, dial Trunk Access Code
'0' to grab a trunk and dial the number.
• To terminate DISA session dial #9 or disconnect the call from your (remote) end.
Special Digit/activity Code to be dialed
on-hook #0
off-hook #1
Flash #2
Pause #3
A#4
B#5
C#6
D#7
+#8
To Terminate the DISA #9
###
End of String #*
To Next Page
Loading...