816 Matrix PRASAR UCS System Manual
If DISA CLI Authentication-Multiple Calls is enabled,
• You will get system dial tone.
• Dial the special digits #1 to go Off-hook, #0 to go On-hook, and make your calls like any local extension.
• To terminate DISA session dial #9 or disconnect the call from your (remote) end.
If DISA CLI Authentication - One Call is enabled,
• You will get Trunk dial tone.
• Dial the external number, without the Trunk Access Code.
• The DISA session will be terminated when you or the remote called party disconnects.
• To make another call, you must dial the number of the DISA enabled trunk again.
To configure DISA Idle State Timer, refer to “System Timers and Counts”.
The features listed below are not supported in the DISA mode.
• Auto Call Back
• Auto Redial
•Call Park
• Call Chaining
• Walk-In Class of Service
• Self Ring Test
• Live Call Supervision
To Next Page
Loading...