EasyManua.ls Logo

Matrix PRASAR UCS - Page 83

Matrix PRASAR UCS
1368 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
74 Matrix PRASAR UCS System Manual
Select Phone VLAN/COS to add VLAN header to the packets generated by the phone, and add VLAN
header to the packets relayed from the PC to its LAN port (packets generated by the PC connected to its
PC port).
To configure Phone VLAN/COS, select Enable?. The VLAN ID will be tagged on all packets generated
by the phone (SIP, RTP, DNS, ARP, etc.). Default: Disabled.
Select VLAN ID and enter the VLAN ID that you have assigned to the VLAN in which the IP Phones are
connected. Valid range: 0-4094. Default: 1.
Select SIP CoS and define the CoS (priority) bits in all SIP packets. Valid range: 0-7. Default: 3
Select RTP CoS and define the CoS (priority) bits in all RTP packets. Valid range: 0-7. Default: 6.
Select PC/VLAN CoS to add VLAN header to all packets entering the PC Port and leaving the LAN port of
the phone. Default: Disabled.
To configure PC VLAN/COS, select Enable?.
Select VLAN ID and enter the same ID as you have assigned to the VLAN in which the computers are
connected. Valid range: 0-4094. Default: 1.
Select CoS and define the Layer 2 CoS (priority) bits. Valid range: 0-7. Default: 0.
PCAP
To capture packets sent and received from and by the phone for monitoring and troubleshooting, you can enable
PCAP on the phone. The phone captures up to 1 MB of packets. For more information and instructions on how to
use PCAP Trace on the phone, refer to the EON510_SPARSH VP510 User Guide.
MAC Cloning
If you require cloning of the MAC Address, configure the following:
Select Enable? and press the Enter key. Select Yes to enable.
•In Enter Clone MAC Address, enter the address you wish to clone.
802.1x Authentication
If you want to restrict unauthorized clients from connecting to your LAN, you need to enable 802.1x Authentication.
Using EAP MD5 protocol the PC connected to the LAN port of the IP Phone is first authenticated and then it gets
connected to LAN.
You need to configure the following 802.1x Authentication parameters:
3 Excellent Effort
4 Controlled Load
5 Video
6Voice
7 Network Control
CoS Traffic Type

Table of Contents

Other manuals for Matrix PRASAR UCS