Matrix PRASAR UCS - Page 84

Matrix PRASAR UCS System Manual 75
• Select Enable? and press the Enter key. Select Yes to enable.
• Enter the 802.1x Authentication Identity provided by you network administrator.
• Enter the 802.1x Authentication MD5 Password associated with identity provided by your network
administrator.
When you change the Network Settings, the phone will restart.
Viewing Network Status
• When the phone is in idle state. You must press the Down key to access the Network Settings.
• Again press Down key to select Network Status and press the Enter key.
Use the Down/Up key to view the status of the various network parameters. The status of the following
parameters appear on your display as you scroll.
• MAC: This is the MAC Address of the phone.
• IP: The current IP Address assigned to the phone.
• MASK: The current Subnet mask assigned to the phone.
• GW: The current Gateway IP Address assigned to the phone.
• DNS: The Domain Name Server address assigned to the phone.
• Active Server: This displays the Server that is active — Primary, Secondary — with which the phone is
currently registered.
• S. ADD: This displays the IP address of the Active Server. It may be the LAN or WAN IP Address /
Domain Name of the PRASAR UCS or the Secondary Server IP Address (if configured) or any Fallback
Server.
•S. PORT: This displays the port of the Active Server. It may be the SPARSH Port of PRASAR UCS or
the Secondary Server Port (if configured) or the Fallback Server Port.
• DOMAIN: The Domain Name assigned to the phone.
• 802.1x Authentication: The 802.1x authentication status is displayed—Success, Failure,
Authenticating or Disabled.
• FIRM: The version of the current Firmware of the phone.
• UBOOT: The UBOOT release date.
• KERNEL: The KERNEL release date.
Refer to the EON510_SPARSH VP510 User Guide to know more.