Matrix PRASAR UCS System Manual 85
To connect the PoE:
• Connect the Ethernet cable between the Internet port on the phone and an available port on the in-line
power switch/hub.
If in-line power switch/hub is provided, you don’t need to connect the phone to the power adapter. Make
sure the switch/hub is PoE-compliant.
Do not unplug or remove power while the phone is updating firmware.
After the IP Phone is assembled and connected to the power supply, it automatically begins the
initialization process.
During this process, the IP Phone displays the start up screen “Welcome Initializing…please wait”.
Once the IP Phone is initialized, it displays two different phone modes:
• Standard SIP
• Extended SIP
• Select Extended SIP, to operate the IP Phone in the extended mode. As soon as you select this mode, the
booting process initiates again and the start up screen displays “Welcome Initializing…please wait”. After
the IP Phone is initialized, it attempts to contact a DHCP Server in your network to obtain valid IPv4
network settings (example: IP address, Subnet Mask, Gateway address, DNS address).You need to
configure the basic network parameters of the IP Phone manually, if these are not provided by the DHCP
Server or if your network does not support DHCP.
Refer to the EXTENDED SPARSH VP710 User Guide, for detailed instructions:
• To change the Network Settings of the phone and configure the network parameters.
• To use Wi-Fi for connectivity and configure its parameters.
• On getting the IP Address and Server Address, the phone initiates Auto Configuration (when DHCP is
selected) to download the configuration files from PRASAR UCS.
• On successful download of all configuration files, the phone attempts to register with PRASAR UCS.
• On successful registration, the Home screen appears.
The phone will register successfully, only if the SIP Extension parameters in PRASAR UCS have been
correctly configured as per your installation scenario.
To Next Page
Loading...