Mercury 305 CID - Page 115

ALPHA DRIVES - WITH DRIVE SHAFT EXTENSIONS - 2B-1190-823225--1 1096
c. Secure throttle cable with hardware (re-
tained) as shown. Tighten cable end guide
nut until it bottoms out and then back off one
full turn. Tighten cable barrel securely. DO
NOT OVER-TIGHTEN, as cable must pivot
freely.
2 Barrel Carburetor
72013
a - Cable End Guide
b - Attaching Hardware (DO NOT Over-Tighten)
c - Cable Barrel
d - Anchor Studs
b
c
d
a
d
b
4 Barrel Carburetor
72014
a - Cable End Guide
b - Attaching Hardware (DO NOT Over-Tighten)
c - Cable Barrel
d - Anchor Studs
b
d
a
c
d
b
b
d. Place remote control throttle lever in the
wide-open-throttle (W.O.T.) position. Check
to ensure that throttle shutters (valves) are
completely open and throttle shaft lever con-
tacts carburetor body casting.
e. Return remote control throttle lever to idle
position and check to ensure that throttle
lever contacts idle speed adjustment screw.
72283
a - Throttle Lever Tang
b - Carburetor Body
c - Idle RPM Adjustment Screw
Mercarb 2 Barrel Carburetor
b
c
a
W.O.
T.
IDL
E
72583
a - Tang
b - Carburetor Body
c - Idle RPM Adjustment Screw
b
c
a
IDLE
W.O.T.
Rochester 4 Barrel Carburetor