HURTH DOWN ANGLE TRANSMISSION - 8C-990-823225--1 1096
Draining Transmission
1. Clean the exterior of transmission before disas-
sembly.
NOTE: Later model Hurth transmissions have an
allen head socket screw on oil filter cover.
2. Remove oil filter from housing by turning (coun-
terclockwise) and pulling at the same time.
27666
a - Set Screw (Later Models)
3. Push hose of suction pump through suction pipe
and down to the bottom of the housing. Pump
fluid from housing.
71043
Filling Transmission
IMPORTANT: Use only Automatic Transmission
Fluid (ATF) as recommended in “Specifications.”
1. Fill transmission to proper level, through oil filter
cavity. (Refer to “Capacity.”)
2. Install filter as follows:
a. Coat O-ring on filter cover with transmission
fluid.
27662
b
a
a - Filter Cover
b - O-Ring
To Next Page
Loading...
