Mercury 305 CID - (PG200, PG250 and PG260) Starter Motor; Specifications; Permanent Magnet Gear Reduction

4A-12 - STARTING SYSTEM 90-823225--1 1096
Permanent Magnet Gear Reduction
(PG200, PG250 and PG260) Starter Motor
Specifications
PG 200 STARTER MOTOR
Delco
No Load Test
I.D.
Number
Volts
Min.
Amps
Max.
Amps
Min.
RPMS
Max.
RPMS
9000762
9000768
10.6 60 90 3000 3000
Brush Spring Tension 83-104 oz. (2353-2948 g.)
Pinion Clearance .010-.160 in. (0.25-4.00 mm)
Bearing Depth (Gear) .011-.014 in. (0.28-0.38 mm)
Bearing Depth (Drive Housing) .009-.017 in. (0.25-0.45 mm)
PG 250 STARTER MOTOR
Delco
ID
No Load Test
I.D.
Number
Volts Min.
Amps
Max.
Amps
Min.
RPMS
Max.
RPMS
9000789 10.6 60 95 2750 3250
Brush Spring Tension 83-104 oz. (2353-2948 g.)
Pinion Clearance .010-.160 in. (0.25-4.00 mm)
Bearing Depth (Gear) .011-.014 in. (0.28-0.38 mm)
Bearing Depth (Drive Housing) .009-.017 in. (0.25-0.45 mm)
PG 260 STARTER MOTOR
Delco
ID
No Load Test
I.D.
Number
Volts Min.
Amps
Max.
Amps
Min.
RPMS
Max.
RPMS
9000789 10.6 60 95 3000 3000
Brush Spring Tension 83-104 oz. (2353-2948 g.)
Pinion Clearance .010-.160 in. (0.25-4.00 mm)
Bearing Depth (Gear) .011-.014 in. (0.28-0.38 mm)
Bearing Depth (Drive Housing) .009-.017 in. (0.25-0.45 mm)