EasyManua.ls Logo

Mercury 305 CID - Special Tools

Mercury 305 CID
967 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
90-823225--1 10965E-8 - ELECTRONIC FUEL INJECTION (MULTI-PORT AND THROTTLE BODY)
Special Tools
Part Number Tool Name Description
J-34029-A(Note 1)
High Impedance Multi-
meter (DVM)
Minimum 10 megohm input impedance required on
all voltage ranges. As ammeter, accurately mea-
sures low value current flow. As ohmmeter, reads
0-200 ohms, 2/20/200 k, 2/20 m
J-23738
Vacuum Pump with
Gauge - 20 In. Hg
Minimum
Gauge monitors manifold engine vacuum. Hand
pump used to check fuel pressure regulator
J-34142-B (Note 2) Unpowered Test Light
Used to check circuit wiring, short to ground, or volt-
age.
91-99379 Timing Light
Used to check ignition timing. Must have inductive
signal pickup.
91-16850A-1 Fuel Pressure Gauge Used to check fuel system pressure.
J-34730-2A
Injector Harness Test
Light
Visually indicates injector electrical impulses from
the ECM.
91-823686A2 Quicksilver Scan Tool
Dis
p
la
y
s
p
roblem codes stored in the ECM. It also
84-822560A2 MERCRUISER Cable
Displays
problem
codes
stored
in
the
ECM
.
It
also
allows monitoring of various circuits and compo-
nents in the fuel injection system
91-822608--1 MERCRUISER Cartridge
nents
i
n t
h
e
f
ue
l
i
n
j
ect
i
on system.
94040M
EFI Scan Tool/Injector
Tester
(Rinda Technologies)
Displays problem codes stored in the ECM. It also
allows monitoring of various circuits and compo-
nents in the fuel injection system. Allows for test fir-
ing injectors.
94008
Diagnostic Code Tool
(Rinda Technologies)
Flashes light to display problem codes
J-35616 Harness Test Adapter Allows multi-meter connections with wiring harness.
91-805918 Fuel Shut Off Tool Used to perform fuel system pressure tests
91-805747A1 Timing Tool Jumper Plug Used to set Ignition timing. Plug connects to DLC
91-806901 Fuel Line Connector Allows connection of Fuel Pressure Gauge
NOTE 1: The High Impedance Multimeter that comes with the existing Outboard EFI Tester (91-11001A1) meets
the requirements listed above.
NOTE 2: Using a test light with 100 mA or less rating may show a faint glow when test actually states no light.
Kent-Moore Tools, Inc.
29784 Little Mack
Roseville, MI 48066
Phone: 800-345-2233
Rinda Technologies
4563 N. Elston Ave.
Chicago, IL 60630
Phone: 312-736-6633

Table of Contents

Related product manuals