8C-8 - HURTH DOWN ANGLE TRANSMISSION 90-823225--1 1096
DUAL CABLE - REAR ENTRY
72960
50073
b
c
d
a
b
e
1
2
1 - Cable Barrel Stud
2 - Cable End Guide Stud
a - Cable End Guide
b - Locknut and Washer (Tighten Until Bottoms Out, Then
Back Off 1/2 Turn)
c - Spacer (Fits Over Bushings)
d - Bushing
e - Cable Barrel
f - Spacers (Fits Over Stud)
Checking Transmission
Fluid Level
IMPORTANT: Use only specified transmission
fluid (see “Specifications”).
Check transmission fluid before starting engine each
day, as follows:
1. Remove dipstick. Check fluid level as indicated
on dipstick. Fluid level may be somewhat over full
mark, as some of the fluid from transmission fluid
cooler and hoses may have drained back into
transmission. If low, add transmission fluid to
bring level up to full mark on dipstick.
27661
Typical Hurth Transmission Shown
IMPORTANT: To accurately check fluid level, en-
gine must be run at 1500 RPM for two minutes im-
mediately prior to checking level.
2. Start engine and run at 1500 RPM for two min-
utes to fill all hydraulic circuits.
IMPORTANT: Be sure to push dipstick all the way
down into dipstick tube when checking fluid
level.
3. Stop engine and quickly check fluid level. Add
automatic transmission fluid, if necessary, to
bring level up to full mark on dipstick. (Refer to
“Filling Transmission,” following.)
4. Reinstall dipstick.
5. If transmission fluid level was extremely low,
carefully check transmission, fluid cooler and
hoses for leaks.
To Next Page
Loading...
