2E-6 - MIE MODELS - VELVET DRIVE TRANSMISSIONS 90-823225--1 1096
IMPORTANT: Large diameter of mount trunnion
MUST NOT extend over 3/4 in. (20 mm) from
mount brackets on any of the mounts.
72599
a - Torque Clamping Screw and Nut on All Four Mount
Brackets to 50 Lb. Ft. (68 N
·m)
b - Tighten Locking Nut on All Four Mounts Securely
c - Bend One of the Tabs on Tab Washer Down onto Flat of
Adjusting Nut
d - Maximum Extension of Large Diameter of Trunnion -
3/4 In. (20 mm)
d
a
c
b
6. Connect propeller shaft coupler to transmission
output flange. Attach couplers together with
bolts, lockwashers and nuts. Torque to 50 lb. ft.
(68 N·m).
NOTE: If propeller shaft coupler has setscrews, the
shaft should be dimpled at setscrew locations. Set-
screws should be safety wired after being tightened
securely.
Engine Connections
IMPORTANT: When routing all wire harnesses
and hoses, be sure they are routed and secured
to avoid coming in contact with hot spots on en-
gine and avoid contact with moving parts.
1. Connect seawater inlet hose to seawater pump
as shown. Tighten hose clamp securely.
72532
a - Seawater Inlet Hose Connection
a
Bottom Hose
2. On All Models With a Walter V-Drive Trans-
mission, connect water inlet hose to the fitting on
transmission.
75191
b
a
a - Water Inlet Fitting
b - Hose
To Next Page
Loading...
