STARTING SYSTEM - 4A-3590-823225--1 1096
Reassembly
1. Install end frame on brush holder. Align holes of
end frame with holes of brush holder. Tighten
screws securely.
b
a
c
d
a - Screw (2)
b - End Cap
c - Brush Holder
d - Armature
2. Install gear and drive over planetary shaft.
74087
b
a
c
a - Planetary Shaft
b - Gear
c - Drive
3. Assemble drive on shaft assembly as follows:
a. Lubricate drive end of shaft assembly with
SAE 10W oil.
b. Place gear over shaft.
c. Slide drive assembly onto shaft with pinion
facing outward.
d. Slide retainer onto shaft with cupped surface
facing end of shaft (away from pinion).
To Next Page
Loading...
