4C-20 - CHARGING SYSTEM 90-823225--1 1096
11. Install tie strap to rectifier stud and stud on brush/
rectifier assembly. Tighten nuts securely.
72823
b
a
a - Studs
b - Tie Straps
12. Install cover with one phillips head screw and two
nuts. Install two leads with nuts.
72963
b
c
a
a - Phillips Head Screw
b - Nuts (4)
c - Leads
13. Install insulator caps.
72078
a
a - Insulator Caps
Installation
1. Position alternator in mounting bracket and in-
stall mounting bolt, washers (if used), spacer and
nut. Place washers (if used), on each side of
spacer. DO NOT tighten securely at this time.
2. Fasten alternator brace to alternator with bolt,
washers and spacer (if used). DO NOT tighten
bolt at this time.
3. Position alternator drive belt on pulleys and ad-
just tension as explained under “Drive Belt Ten-
sion Adjustment.”
4. Reconnect wiring harness to alternator and neg-
ative battery cable to battery.
72838
b
c
d
a
a - Excitation Lead -(PURPLE)
b - Sensing Lead - (RED / PURLPE)
c - Ground Lead - (BLACK)
d - Output Lead - (ORANGE)
To Next Page
Loading...
