8B-4 - VELVET DRIVE V-DRIVE AND WALTER V-DRIVE TRANSMISSIONS 90-823225--1 1096
Transmission Shift Lever
The lever has three holes as illustrated following.
71304
Shift Cable Adjustment
Refer to Section 2E - “MIE Models - Velvet Drive
Transmissions.”
Checking Transmission
Fluid Level
IMPORTANT: Use only specified transmission
fluid (see “Specifications”).
Check transmission fluid before starting engine each
day, as follows:
1. Remove dipstick. Check fluid level as indicated
on dipstick. Fluid level may be somewhat over full
mark, as some of the fluid from transmission fluid
cooler and hoses may have drained back into
transmission. If low, add specified transmission
fluid to bring level up to full mark on dipstick.
72526
b
c
a
a - Dipstick
b - Full Mark
c - Dipstick Tube
IMPORTANT: To accurately check fluid level, en-
gine must be run at 1500 RPM for 2 minutes im-
mediately prior to checking level.
2. Start engine and run at 1500 RPM for 2 minutes
to fill all hydraulic circuits.
IMPORTANT: Be sure to push dipstick all the way
down into dipstick tube when checking fluid
level.
3. Stop engine and quickly check fluid level. Add
transmission fluid, if necessary, to bring level up
to full mark on dipstick.
4. Reinstall dipstick.
5. If transmission fluid level was extremely low,
carefully check transmission, fluid cooler and
hoses for leaks.
To Next Page
Loading...
