STARTING SYSTEM - 4A-2790-823225--1 1096
9. Install thru bolts and brush lead. Tighten fasten-
ers securely.
IMPORTANT: Do not overtighten thru bolts. Over-
tightening will bend end frame.
72060
b
a
a - Thru Bolts
b - Brush Lead
Installation
IMPORTANT: Install special mounting shim (if
equipped) between starter motor and engine
block.
1. Place starter motor in position and install mount-
ing bolts. Torque bolts to 30 lb. ft. (41 N·m).
2. Connect YELLOW/RED wire to terminal S of so-
lenoid. Connect ORANGE wire, RED wire, and
battery cable to large terminal of solenoid. Tight-
en fasteners securely. Coat terminals with Quick-
silver Liquid Neoprene. Install battery cable boot,
if so equipped.
3. Connect battery cables to battery in the following
order. Connect positive (+) cable to positive (+)
battery terminal and tighten cable clamp. Then
connect negative (–) cable to negative (–) termi-
nal and tighten clamp.
To Next Page
Loading...
