STARTING SYSTEM - 4A-2390-823225--1 1096
INSTALLATION
IMPORTANT: Brush holder must be installed on
armature before installing armature bearing.
Using the correct size driver, press on inner bearing
race until it contacts shoulder of armature shaft.
Gear Bearing
REMOVAL
Using the correct size driver, press bearing out of
gear.
INSTALLATION
1. Using the correct size driver, press bearing into
gear, from direction shown, to depth (a).
72625
INSTALLATION
DIRECTION
a
a - See Specifications
2. Lubricate bearing and gear teeth with a small
amount of Quicksilver 2-4-C Marine Lubricant
with Teflon.
Shaft Assembly Bearing
IMPORTANT: Roller bearing is not replaceable. If
bearing is defective, replace entire shaft assem-
bly. Apply Quicksilver 2-4-C Marine Lubricant
with Teflon to bearing before starter reassembly.
72070
a
a - Roller Bearing
Drive End Housing Bearing
REMOVAL
Using the correct size driver, press bearing out of
housing.
INSTALLATION
1. Using the correct size driver, press bearing into
housing, from direction shown, to depth (a).
72626
a
b
a - See Specifications
b - Installation Direction
2. Lubricate bearing with a small amount of Quick-
silver 2-4-C Marine Lubricant with Teflon.
To Next Page
Loading...
