Mercury 305 CID - Filling Transmission

8B-6 - VELVET DRIVE V-DRIVE AND WALTER V-DRIVE TRANSMISSIONS 90-823225--1 1096
Filling Transmission
VELVET DRIVE
IMPORTANT: Use only specified automatic trans-
mission fluid (see “Specifications”).
1. Remove dipstick. Fill transmission with fluid,
through dipstick hole, to bring up to full mark.
72526
b
c
a
a - Dipstick
b - Full Mark
c - Dipstick Tube
IMPORTANT: To accurately check fluid level, run
engine at 1500 RPM for 2 minutes immediately
prior to checking level.
2. Start engine and run at 1500 RPM for 2 minutes
to fill all hydraulic circuits.
NOTE: Be sure to push dipstick all the way down into
dipstick tube when checking fluid level.
3. Stop engine and quickly check fluid level. Add
automatic transmission fluid, if necessary, to
bring level up to full mark on dipstick.
4. Reinstall dipstick. Be sure to tighten T-handle
securely.
WALTER V-DRIVE
1. Remove dipstick from top cover. Fill transmission
with fluid, through dipstick hole, to bring up to full
mark.
75192
a
a - Dipstick
IMPORTANT: To accurately check fluid level, run
engine for 2 minutes immediately prior to check-
ing level.