Mercury 305 CID - Engine Connections

MCM MODELS- BRAVO MODELS WITH DRIVE SHAFT EXTENSIONS - 2D-990-823225--1 1096
14. Apply Loctite 8831 to threads of bottom drive
shaft shield retaining screws and install bottom
shields on engine and transom end as shown.
Torque screws to 30 lb. ft. (41 N·m). Then install
both top shields as shown. Torque screws and
nuts to 30 lb. ft. (41 N·m).
70245
Top Shield and Bottom Shield at Transom End
(Engine End Similar)
a - Top Shield
b - Bottom Shield
c - Bolt 3/8-16 x 7/8 In. (22 mm Long) (4 Used)
d - Nut 3/8-16 (4 Used)
e - Screws (3 Used - Hidden in This View) (Use Loctite 271)
c
d
a
e
b
15. Proceed to “Engine Connections” section in-
structions following.
Engine Connections
IMPORTANT: When routing all wire harnesses
and hoses, be sure they are routed and secured
to avoid coming in contact with hot spots on en-
gine and avoid contact with moving parts.
1. Connect seawater inlet hose to seawater pump
as shown. Tighten hose clamp securely.
72532
a
a - Seawater Inlet Hose Connection
2. Connect instrument harness to engine harness
with hose clamp. Tighten clamp securely.
72025
a - Engine Wiring Harness Receptacle Bracket
b - Instrumentation Wiring Harness Plug
c - Hose Clamp - Tighten Securely
b
c
a