8A-4 - VELVET DRIVE IN-LINE TRANSMISSION 90-823225--1 1096
Transmission Shift Lever
The lever has three holes as illustrated following.
71304
Shift Cable Adjustment
Refer to Section 2C - “MIE Models - Borg-Warner
Transmissions.”
Checking Transmission
Fluid Level
IMPORTANT: Use only specified transmission
fluid (see “Specifications”).
IMPORTANT: To accurately check fluid level, en-
gine must be run at 1500 RPM for 2 minutes im-
mediately prior to checking level.
72526
b
c
a
a - Dipstick
b - Full Mark
c - Dipstick Tube
1. Start engine and run at 1500 RPM for 2 minutes
to fill all hydraulic circuits.
IMPORTANT: Be sure to push dipstick all the way
down into dipstick tube when checking fluid
level.
2. Stop engine and check fluid level. Add transmis-
sion fluid, if necessary, to bring level up to full
mark on dipstick.
3. Reinstall dipstick. Be sure to tighten T-handle se-
curely. DO NOT over tighten.
4. If transmission fluid level was extremely low,
carefully check transmission, fluid cooler and
hoses for leaks.
To Next Page
Loading...
