2D-10 – MCM MODELS - BRAVO MODELS WITH DRIVE SHAFT EXTENSIONS 90-823225--1 1096
3. Connect two trim position sender leads from gim-
bal housing to leads from engine harness.
72582
a - Brown/White (From Engine Harness)
b - Black (From Engine Harness)
c - Black (From Transom Assembly)
d - Black (From Transom Assembly)
b
c
d
a
Throttle Connections
!
WARNING
Be careful when working on fuel system. Gaso-
line is extremely flammable and highly explosive
under certain conditions. Do not smoke or allow
spark or open flame in area. Wipe up any spilled
fuel immediately.
Fuel Supply Connections
!
WARNING
Avoid gasoline fire or explosion. Improper instal-
lation of brass fittings or plugs into fuel pump or
fuel filter base can crack casting and/or cause a
fuel leak.
• Apply #592 Loctite Pipe Sealant with Teflon to
threads of brass fitting or plug. DO NOT USE
TEFLON TAPE.
• Thread brass fitting or plug into fuel pump or
fuel filter base until finger tight.
• Tighten fitting or plug an additional 1-3/4 to
2-1/4 turns using a wrench. DO NOT
OVER-TIGHTEN.
• Install fuel line. To prevent over-tightening,
hold brass fitting with suitable wrench and
tighten fuel line connectors securely.
• Check for fuel leaks.
4. Connect fuel line from fuel tank(s) to engine.
Make certain connections are secure. Check for
leaks.
5. Connect throttle cable(s) using hardware re-
tained and adjust as follows:
a. Place remote control handle(s) in neutral, idle
position.
IMPORTANT: Be sure that cable is routed in such
a way as to avoid sharp bends and/or contact
with moving parts. DO NOT fasten any items to
throttle cable. Outer cable must be free to move
when cable is actuated.
b. Install cable end guide on throttle lever, then
push cable barrel lightly toward throttle lever
end. (This will place a slight preload on cable
to avoid slack in cable when moving remote
control lever.) Adjust barrel on throttle cable
to align with anchor stud.
c. Secure throttle cable with hardware (re-
tained) as shown. Tighten cable end guide
nut until it bottoms out and then back off one
full turn. Tighten cable barrel securely. DO
NOT OVER-TIGHTEN, as cable must pivot
freely.
2 Barrel Carburetor
72013
a - Cable End Guide
b - Attaching Hardware (DO NOT Over-Tighten)
c - Cable Barrel
d - Anchor Studs
b
c
d
a
d
b
To Next Page
Loading...
