4A-36 - STARTING SYSTEM 90-823225--1 1096
e. Position snap ring on upper end of shaft and
hold in place with block of wood. Strike wood
block with hammer, thus forcing snap ring
over end of shaft. Slide snap ring down into
groove.
72073
b
a
c
a - Snap Ring
b - Groove
c - Retainer
f. Assemble thrust collar on shaft with shoulder
next to snap ring.
g. Position retainer and thrust collar next to
snap ring. Then, using two pliers, grip retainer
and thrust collar and squeeze until snap ring
is forced into retainer.
72074
b
c
a
a - Retainer
b - Thrust Collar
c - Snap Ring
4. Install the planetary gears on planetary shaft.
5. Install solenoid arm and rubber grommet in the
drive housing.
74135
a
b
c
a - Rubber Grommet
b - Solenoid
c - Drive Housing
6. Install drive and associated parts in drive hous-
ing.
b
74035
a
a - Drive Housing
b - Drive
To Next Page
Loading...
