ALPHA DRIVES - WITH DRIVE SHAFT EXTENSIONS - 2B-1390-823225--1 1096
a
b
74183
c
d
74174
Multi-Port Injection
a - Lock Nut and Flat Washer Tighten Until Bottoms Out, Then
Back Off One Half Turn.
b - Cable End Guide
c - Throttle Cable Anchor Stud
d - Cable Barrel
7. Secure throttle cable with hardware as shown
and tighten securely.
NOTE: If Boat is equipped with Quicksilver Zero Ef-
fort Controls, the throttle cable mounting stud must
be most forward position on throttle lever.
73855
a
a - Position for Zero Effort Controls
IMPORTANT: Do not attach any accessory
ground (–) wires to transom plate ground point.
Accessory ground wires should only be attached
to ground stud on engine.
To Next Page
Loading...
