2E-8 - MIE MODELS - VELVET DRIVE TRANSMISSIONS 90-823225--1 1096
NOTICE
Exhaust hoses must be connected to
exhaust elbows so that they do not restrict
the flow of discharge water from exhaust
elbow. If hoses are connected incorrectly,
discharge water from exhaust elbow will not
flow around entire inside diameter of hose.
This will cause a hot spot in the hose which
may eventually burn through.
CORRECT
INCORRECT
Clamps Not Shown
72538
IMPORTANT: BLACK SCORPION S-pipes must
be routed under the transmission mounts.
74832
a
a - S-Pipe
6. Connect and adjust Quicksilver shift cable(s) as
outlined following:
IMPORTANT: When installing shift cables, be
sure that cables are routed in such a way as to
avoid sharp bends and/or contact with moving
parts. DO NOT fasten any items to shift cables.
NOTE: On models with other than Quicksilver shift
cables refer to shift cable manufacturer’s instructions
or, if so equipped, to following separate section - “At-
taching/Adjusting Reversed Attachment Morse Shift
Cables.”
IMPORTANT: Velvet Drive Transmission Warran-
ty is jeopardized if the shift lever poppet ball or
spring is permanently removed, if the shift lever
is repositioned or changed in any manner or if re-
mote control and shift cable do not position shift
lever exactly as shown.
72601
b
c
FN R
d
a
a - Transmission Shift Lever
b - Shift Lever Must Be Over This Letter when Propelling
Boat FORWARD
c - Shift Lever Must Be Over This Letter when Propelling
Boat in REVERSE
d - Poppet Ball Must Be Centered in Detent Hole for Each
F-N-R Position (Forward Gear Shown)
To Next Page
Loading...
