ENGINES - 3A-4390-823225--1 1096
5. Install dipstick tube and dipstick. On MIE mod-
els, install dipstick tube as follows:
a. Install banjo fitting as shown. Do not tighten
banjo fitting bolt at this time.
NOTE: Dipstick tube can be positioned on either side
of engine.
b. Install dipstick tube and secure with hardware
as shown. Do not tighten tube at banjo fitting
until after tube has been secured at manifold.
c. Install plug in banjo fitting.
d. Tighten all connections on banjo fitting at this
time. Torque banjo fitting bolt to 180 lb. in. (20
N⋅m). Tighten dipstick tube and plug securely.
e. Install appropriate gage.
6. Fill crankcase with required quantity of oil of spe-
cified viscosity. See Section 1B - “Maintenance.”
71859
a - Banjo Fitting
b - Banjo Fitting Bolt
c - Plug
d - Gaskets
e - Dipstick Tube
f - Clamp (Secured by Manifold Screw)
g - Gage
71860
e
f
e
g
71861
d
b
c
b
c
a
To Next Page
Loading...
